Datamax-oneil I-Class Mark II Wired_Wireless LAN Option Instrukcja Użytkownika Pobierz pdf

Wired/Wireless LAN Option

92-2587-01 Rev.A

1 2 3 4 5 6 7 8 9 10

Wired/Wireless LAN Option92-2587-01 Rev.A

3 Overview This document describes the installation and use of the Wired/Wireless LAN option for the I-Class Mark II printer. Follow the steps to

4 Installing the Option Install the LAN Card as described below: A) Turn off and disconnect the power cord from the printer. Remove the three Scr

5 C) Remove the 5mm Screw and Cover Plate from the rear of the printer. Cover Plate5mm Screw D) Install the two 6mm Standoffs into t

6 E) Install the LAN Card into the printer. First insert the “Port” end into the cut-out in the rear of the printer. Then pivot the LAN Card onto th

7 Installing Wireless Module and Antenna Install the Wireless Module and Antenna as described below:: A) Orient the Wireless Module as shown and i

8D) Insert the Antenna Connector through the hole in the printer’s Back Panel. E) Re-install the Nut and Washer onto the Antenna Connector and tigh

9G) Screw the Antenna onto the Antenna Connector and pivot the Antenna up for best reception. AntennaAntenna H) Wireless installation is complete

Brak uwag

Datamax-oneil I-Class Mark II Wired_Wireless LAN Option Instrukcja Użytkownika