Datamax-oneil Performance series User Guide Instrukcja Użytkownika Pobierz pdf (Strona 46)

3 | Connections and Setup

Performance Series User’s Guide 38

6. Select the Paper Sensor Type button until your paper type appears. The options

are as follows:

•Gap

• Mark on Top

• Mark on Bottom

•Notch

• Continuous

Note: For more information, refer to the section “Top-of-Form Sensor.”

7. Select the Paper Sensor Side button until the correct option appears. The options

are as follows:

•Outside

• Inside

Note: For more information, refer to the section “Top-of-Form Sensor.”

8. Select the Ribbon Mode button until the correct option appears. The options are as

follows:

•None

• Coated In (CSI)

• Coated Out (CSO)

Note: For more information, refer to the section “Top-of-Form Sensor.”

Note: CSI ribbon (shiny side facing outward) should be installed where the ribbon

unwinds in a counter-clockwise direction. CSO ribbon (dull side facing outward) should

be installed where the ribbon unwinds in a clockwise direction. If these settings do not

match the ribbon type being used, the ribbon supply hub will turn in the wrong direction.

Setting the Media and Ribbon Parameters Manually (Advanced)

There are times when all print parameters must be set manually. This can happen when

a new or specialized media or ribbon are being used. This advanced procedure will use

the Custom Manual utility.

Note: Some values may be grayed-out, meaning they are automatically set by default.

To change these values, select the Auto button next to the value field and then select the

green Accept button to confirm your choice to change to manual mode.

Note: Please see the Menu section for more information.

1. Select Menu > Advanced > Media.

2. Select the Paper Sensor Type field until the correct paper type appears. The

options are as follows:

1 2 ... 41 42 43 44 45 46 47 48 49 50 51 ... 142 143

Brak uwag

Datamax-oneil Performance series User Guide Instrukcja Użytkownika Strona 46