Datamax-oneil RL3_4 User Guide Instrukcja Użytkownika Pobierz pdf (Strona 34)

Calibrate the Presenter Sensor:



After calibration is complete the presenter sensor will be disabled. You must re-enable the presenter

before use.

1) Install the media in the printer

and route the liner through the

peeler door, see section 2.3.1.

When the FEED key is pressed,

the label will be peeled and

presented for the operator.

2) Click on the ‘Sensor Calibration’

printer component.

3) Click the ‘Presenter Sensor’

button to start the calibration

process.

Follow the instructions on the

following screen.

4) Type the number 6 as the

Advance Distance after

QMark/Gap. Click the ‘OK’

button.

This value may vary if

Datamax-O’Neil media is not

used and may require

adjustments to the Advance

Distance after QMark/Gap

parameter for the sensor to

work properly.

5) The following screen will be

shown. Click the ‘OK’ button to

start the process.

After the calibration is

performed successfully, the

following confirmation screen

will be shown. If the sensor

calibration fails, repeat the

process.

312



Media Backing



Peeler Door

Note: To test the proper operation of the printer, press the Feed button. The label is separated from the

liner and a message “REMOVE LABEL” is shown in the LCD. After the label is removed, the printer will

print the next label.

1 2 ... 29 30 31 32 33 34 35 36 37 38 39 ... 69 70

Komentarze do niniejszej Instrukcji

Brak uwag

Datamax-oneil RL3_4 User Guide Instrukcja Użytkownika Strona 34

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Drukarki Datamax-oneil RL3_4 User Guide