Datamax-oneil Workstation series Programmer’s Guide Instrukcja Użytkownika Pobierz pdf (Strona 37)

Programmer’s Guide | 1

31 Thermal Printer Programmer’s Guide

<ESC>%-12345X@PJL JOB NAME = "JOB_CLEAN_END" <LF>

@PJL PERFORM HEADCLEANMODE = 0 <LF>

@PJL EOJ <LF>

PJL Cutter, Rewinder, and Ribbon Assembly Self-Test Commands

Prior to performing self test procedures for options, the self test mode must be entered

as the following:

<ESC>%-12345X@PJL JOB NAME = "JOB_SELFTEST_INIT" <LF>

@PJL PERFORM SELFTEST = 1 <LF>

@PJL EOJ <LF>

For rewinder or ribbon assembly tests the media should be detached from the

mechanism. To perform the rewinder test, issue the following:

<ESC>%-12345X@PJL JOB NAME = "JOB_REWIND_TEST" <LF>

@PJL PERFORM REWIND <LF>

@PJL EOJ <LF>

Ribbon front and back assemblies can be tested using the PERFORM RIBBONFRONT

or RIBBONBACK commands, respectively.

For testing the cutter, insert a value for the number of cuts as seen below.

<ESC>%-12345X@PJL JOB NAME = "JOB_REWIND_TEST" <LF>

@PJL PERFORM CUT = n <LF>

@PJL EOJ <LF>

“n” is the number of cut cycles to perform.

View test results by using the PJL INFO SYSTEMSTATUS read-back command. The

value LASTLBLCNT is the total cycles requested and ERRORCOUNT is the number that

failed.

The PERFORM ABORTALL command is used to cancel ongoing tests. To re-test and

clear counters issue PERFORM SELFTEST = 2

When the self tests are complete the command below can be used to disable the self test

mode:

<ESC>%-12345X@PJL JOB NAME = "JOB_SELFTEST_END" <LF>

@PJL PERFORM SELFTEST = 0 <LF>

@PJL EOJ <LF>

PJL GPIO Self Test

Prior to performing self test procedures for GPIO the self test mode must be entered as

follows:

1 2 ... 32 33 34 35 36 37 38 39 40 41 42 ... 58 59

Brak uwag

Datamax-oneil Workstation series Programmer’s Guide Instrukcja Użytkownika Strona 37