Datamax-oneil H-Class Operator’s Manual Instrukcja Użytkownika Pobierz pdf (Strona 99)

H-Class 89

Advanced Entry Calibration (continued)

Step

Action Displayed Message Comment

Press and hold the FEED

Key until at least one label

has been output.

CALIBRATION COMPLETE

Followed by...

READY

The printer is ready for

use.



If the calibration

attempt fails, try

desensitizing the

sensor as follows:

Re-enter the

ADVANCED MENU. Go

to MEDIA SETTINGS /

SENSOR

CALIBRATION /

ADVANCED ENTRY /

TRAN (or REFL)

SENSOR GAIN and

lower the

corresponding GAIN

SETTING by one. Exit

the menu and save

your changes. Test

your media at the

new setting. If

necessary, repeat

until a usable Gain

Setting is obtained.

5.3 Reset Methods

There are three reset levels for the printer.

5.3.1 Soft Reset

Soft Reset clears temporary host settings. To perform a Soft Reset:

• Press and hold the CANCEL Key (see Section 4.1) for approximately four seconds.

1 2 ... 94 95 96 97 98 99 100 101 102 103 104 ... 179 180

Brak uwag

Datamax-oneil H-Class Operator’s Manual Instrukcja Użytkownika Strona 99